LED DIY: AC Controls

[Mikey]

Fixed Chris. The 2 i was refering to are the filters for/behind the AC/MODE buttons.

 

[Mikey]

Alex (LeAccord) brought to my attention that the filter for the AC display can be removed. It was a borderline PITA, lol. I'll try to wedge pics in on the OP.

 

[RedRyder]

Fixed Chris. The 2 i was refering to are the filters for/behind the AC/MODE buttons.

Ok that's what I thought, but I just didn't see those two in any of the photos. Because I don't think I took them out when I swapped my HVAC's. Looks like I'm taking it out again.

 

[Simkid5614]

If you're already at the filter is it that much more work to reverse polarize?

 

[Mikey]

You'll need the polarizing film and everything else needed to do that. It's not too difficult. If you wanna do it, might as well do it while you've got everything pulled apart.

 

[Dukebb23]

Hey,
Would it be the same amount of bulbs and sizes for the regular controls ac unit and not the digital/climate control display ac unit?

 

[Mikey]

I couldn't tell you. What I can tell you is that www.hondaautomotiveparts.com lists both types of AC units and it should tell you what bulbs it requires and how many.

 

[Dukebb23]

Yeah I am not sure which ones I need. I do know that there are 4 bulbs but not sure what sizes are needed.
I bought all the ones on this thread through super bright LEDs so I guess I will have enough as long as its not more than one of the 3mm.
Here's the link if you think you can figure it out
http://www.hondaautomotiveparts.com/auto/jsp/mws/prddisplay.jsp?inputstate=5&catcgry1=ACCORD&catcgry2=1999&catcgry3=4DR+EX-UL&catcgry4=KL4AT&catcgry5=HEATER+CONTROL+%28+98-00%29

 

[Mikey]

It shows that you need 4 bulbs but 3 of them are the same bulbs and then the one by itself.

Im not sure what mm they are but it says that the 3 are 14V 100ma, and that single one is 14v 80ma.

 

[Dukebb23]

Yeah I had no clue either.
I just thought maybe someone had done this before.