two of my endlink bolts are stripped (the 5mm hex key part is rounded out).
so the connections are pretty loose. both of the bolts are on the same side.
i tried clamping on to the threads but could not hold tight enough. i also
tried slotting out the bolt and using a flat head to get it to turn, but couln't
get enough torque to get the nut to turn
anyone know that part number for the replacement bolts:
http://www.hondaautomotiveparts.com...4DR+LX&catcgry4=KA5MT&catcgry5=REAR+LOWER+ARM
i think i'm just gonna have to cut off the old ones and install some new ones.
also, is there any danger (of damaging my car or worse) in having a loose rear sway bar?
so the connections are pretty loose. both of the bolts are on the same side.
i tried clamping on to the threads but could not hold tight enough. i also
tried slotting out the bolt and using a flat head to get it to turn, but couln't
get enough torque to get the nut to turn
anyone know that part number for the replacement bolts:
http://www.hondaautomotiveparts.com...4DR+LX&catcgry4=KA5MT&catcgry5=REAR+LOWER+ARM
i think i'm just gonna have to cut off the old ones and install some new ones.
also, is there any danger (of damaging my car or worse) in having a loose rear sway bar?