Also, does anyone have a picture of this: Step 18: **IMPORTANT - IMPORTANT - IMPORTANT** NOTE: IF YOU ARE CHANGING JUST THE SPRINGS AND PLAN ON RE-USING THE FACTORY SHOCKS, PAY CLOSE ATTENTION, OTHERWISE SKIP TO THE NEXT STEP. If you notice on the bottom of the spring perch, there are metal tabs protruding on each end. This must be perfectly aligned with the top mount when you reassemble the suspension. This is where the thin masking tape comes in. Run the masking tape straight from one of the tabs to the bottom of the shock. Next, run the masking tape across the top of the mount so when you look straight down from the top, you will see a line going straight down all the way to the bottom.
I'm confused, thanks