Valet's 2002 Coupe

[Valet]

cleansleeper's 2002 Accord coupe SE (56K)

Grabbed the light meter and work and it turns out the tint ends up being 25%.

Chances are its 90% from factory. Our tints are not that far off from advertised so there's no way I'd be that low unless its tinted from factory.

 

[Valet]

cleansleeper's 2002 Accord coupe SE (56K)

Rear sway

 

[Valet]

cleansleeper's 2002 Coupe

Gonna start tearing out my current audio.

Doing a complete overhaul with a nice headunit and digital design for everything else.

So far the plan is CXS 6.5 and CXS 6x9 powered by the C4C 4 channel amp. Then two 1510A subs powered by a M1C amp. To keep it simple, that'll be 60 watts rms to each speaker, and 600 watts rms to each sub. I'll be at least deadening the trunk and doors as well as sealing the 6x9's. Beyond that, I may be considering an upgraded alternator and definitely a dry cell battery. Doing the Big 3 is also a must for this, so that'll get done. Capacitor will also be added most likely.

Whether or not I'll do a custom enclosure for the subs and/or amps is up in the air at this point.


Edit: Pics on OP are still out of date

 

[Valet]

cleansleeper's 2002 Coupe

Change of plans slightly. I will be stepping up to 2 DD 2512's with an M2b amp. So that'll be roughly 850 rms each. If everything works out space wise, I'll have a custom enclosure made with the rear 6x9 holes being used as ports into the cabin. As in the box will have specific vents that go through the 6x9 slots. I guess more volcano in shape leading up to them. Though this may be very difficult to accomplish but... I think I, and everyone else at work, can make it happen.

I know 850 watts each (1700) doesn't sound like a lot particularly. But in this situation it'll be hitting pretty god damn hard. I'd even consider doing 15's, but I won't step up to 3500's or an M3 amp.

 

[Valet]

cleansleeper's 2002 Coupe

Upped the level again

Changes include a 160amp alt from Ohio Generator and scaling up to 2 DD 3512's each powered by a CM1000 class A/B amp. In the end each wired to ~0.7-1ohm (actually reading)

This suckers gonna be loud!

Went with the large cabin fiber cone and cap with silver logo. So basically this:

 

[Valet]

Cars current height: 23" ground to fender all 4 corners.