cmgreensr
Well-Known Member
Drivers side sunroof drain clogged?
What'd you do to your accord today?
- Thread starter HondaLuver83
- Start date
Drivers side sunroof drain clogged?
DizzyP
Well-Known Member
Might be it. Check out this thread for some easy testing and fix.
Moonroof drain r&r http://www.6thgenaccord.com/forums/showthread.php?t=48037
Sent from my iPhone using Tapatalk
Moonroof drain r&r http://www.6thgenaccord.com/forums/showthread.php?t=48037
Sent from my iPhone using Tapatalk
danmccormick87
Well-Known Member
Not that I can tell, but the gasket around the door is torn in multiple places, so wondering if that might be it...
cmgreensr
Well-Known Member
You could be right but I'd snake the drain tubes out for cheap insurance. Bicycle brake cable and 10 minutes. Bam, done
DizzyP
Well-Known Member
Well, Bam....hope you're done. Good luck, sir 
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Took a picture today. Also a wash. Taillights are darker than this but my camera doesn't quite catch it.
Can someone tell me how much spacer I need in the rear to have the wheel flush like in the front? Looks like a lot
Can someone tell me how much spacer I need in the rear to have the wheel flush like in the front? Looks like a lot
Valet
IS300 SX > Accord
Took a picture today. Also a wash. Taillights are darker than this but my camera doesn't quite catch it.
Can someone tell me how much spacer I need in the rear to have the wheel flush like in the front? Looks like a lot
Probably 15-20mm
And go a lot lower.
Not happening. Can't afford to lose any more ground clearance. I have plans for this.
Brimstone Brown
Well-Known Member
Spent all day yesterday underneath her trying to swap out my lower balljoints and lca bushings. It did not go well for me. I couldn't get the hub off of the axle. I have determined that the lca bushings are indeed the source of all the ruckus my front end has been making. I didn't have a press and thought I could make it work with my large vise. It was much more stubborn than anticipated. My advice to anyone needing to do this is to buy the arms with the bushings pre pressed. Oh yeah then today I had a blowout....
