What'd you do to your accord today?
- Thread starter HondaLuver83
- Start date
I went to a local yard and picked up a TL Strut tower bar for a whoppin $0 talk about luck 
also picked up a spair tail light set which i blacked out the side lights and painted the middle to match the car (minus the reverse lights). Installing tomorrow!
also picked up a spair tail light set which i blacked out the side lights and painted the middle to match the car (minus the reverse lights). Installing tomorrow!
DizzyP
Well-Known Member
Zero dollars?! You must be pretty good at out running the junk yard dogs. LOL.
iPhone using Tapatalk, sent from my.
iPhone using Tapatalk, sent from my.
SykVSyx
Well-Known Member
That's how much the spare one I have cost me as well.
No dogs to outrun, though.
Should be getting the car back today after the new alternator and a couple little things get done.
RedRyder
Save the manuals
^get that leak taken care of?
SykVSyx
Well-Known Member
No, not yet. Coming up on several maintenance things to get done, but some are going to be DIY, because costly.
It hasn't been as bad lately, for some reason.
Looked up the necessary part and was very disheartened to find out it's less than $20 for the part, and the labour to replace it is in the $100's........
RedRyder
Save the manuals
Yeah things like oil seals are like that.
How many miles were on that motor when you put it in?
How many miles were on that motor when you put it in?
SykVSyx
Well-Known Member
91k+, approximately, at time of install.
Also, I almost forgot, I need to take that third brake light pic for you as well.
Will get to that, asap.
Also, I almost forgot, I need to take that third brake light pic for you as well.
Will get to that, asap.
Last edited:
RedRyder
Save the manuals
Bought a replacement purge valve solenoid...wish it would magically get rid of my p1456. 
Also picked up some LED's for interior accent lighting - cubby/cupholder. Going to try these:
And those rear caliper brackets...
Also picked up some LED's for interior accent lighting - cubby/cupholder. Going to try these:
And those rear caliper brackets...
Last edited:
SykVSyx
Well-Known Member
I have the full interior LED line-up that I got from Jeff(Jephu) awhile back.
Need to switch out the blue lighting and get the white in there.
I have thought about the cupholder one as well, but sometimes I have drinks that condense and I wasn't sure if that would be an issue.
Need to switch out the blue lighting and get the white in there.
I have thought about the cupholder one as well, but sometimes I have drinks that condense and I wasn't sure if that would be an issue.
