98 Accord LX 2.3 is running rough

[mikewohlwend]

Figured I'd ask On here to see if anyone has any ideas. Swapped my motor for a JDM not I can't get the car running right.

It idles fine. When I hit the throttle get to about 2000rpm then just cuts out.

New o2 sensors
new plugs & wires

http://vid8.photobucket.com/albums/a25/mikewohlwend/Mobile Uploads/20150427_170540_zpshtq5vhfp.mp4

 

[james'99]

And no check engine lights?

 

[mikewohlwend]

Have the dash torn apart currently. Going to throw it back together tomorrow.

 

[james'99]

No OBDII scanner?

 

[mikewohlwend]

I don't have a scanner.

 

[bairdandrew77]

Borrow one from AutoZone. Over here you can give them your id or pay to rent, then you get everything back when you return the tool

 

[mikewohlwend]

I was going to call them in the morning to see what this would run. I have already talked to a dealership to see what they charge. Are there any places that sell them for a decent price? I know Harbor Frieght sells them, but don't know about the quality.

 

[twofast4u]

Which intake manifold are you using? USDM or JDM? Also, Check your map sensor as well. When i did my swap, my old one stopped working and i had to use the jdm one.

 

[james'99]

One that just gives you the code numbers is fine. If you want it to do a lot, you will pay a lot. I just don't think that is necessary in this case.

Dual purposed though? Try http://www.ultra-gauge.com/ultragauge/

There is also a bluetooth dongle xci likes to recommend. I haven't personally used it but I think it's very viable. Pair that with the Android app, Torque, and you are good to go.

 

[mikewohlwend]

Which intake manifold are you using? USDM or JDM? Also, Check your map sensor as well. When i did my swap, my old one stopped working and i had to use the jdm one.

Only thing I changed from the USDM motor is the throttle body.