stupid people.....

SykVSyx

Well-Known Member
Joined
Jan 6, 2007
Posts
13,939
Reaction score
30
Location
Tee Dot Ohh
Reminds me of a song I once knew, "cars ride by with the boomin' system....."....ah, the classics.
 

djslik

Member
Joined
Feb 19, 2013
Posts
9
Reaction score
0
Location
SF Bay Area
Get a Fluke Meter and measure maximum output voltage at your speaker terminals. Adjust your system gains and amp gains to allow playing of all music at full blast while keeping the maximum voltage output below the RMS value of your speaker. You will need to know your speaker impedance in RMS watts in order to calculate maximum voltage.

V=IR
P=IV
I=V/R
P=V^2/R
Voltage Max=SQRT(Power RMS(watts)xResistance (ohms))

This is the same way you tune a system for concerts and clubs with big PA's. Playing Skrillex loud shouldn't be a problem if your system is tuned.

Here's what I do for my systems:
1. Find a loud song with lots of bass between 35-100 hz like dubstep or run sinewave sweeps between 30-100 Hz.
2. Disconnect Subwoofer terminals
3. Adjust head unit crossover points to 80hz high and low pass
4. Turn up song to full blast and maximum bass on head unit
5. Attach fluke meter to amp terminal outputs
6. Measure VDC Voltage and record maximum voltage spike
7. Adjust gains on amp until voltage spike is below your RMS voltage calculated above.
8. Reconnect Subwoofer
9. Enjoy your system as loud as you want since you have reduced the likelyhood of grenading your subwoofer.

If you are not happy with bass output then you need a larger subwoofer or more subwoofers.
 
Last edited:
Back
Top