Clutch Master C Issue!!!!

[BkzTafetta]

So this is my third Clutch Master Cylinder i am putting on my car in less than 2 years.....my first one when i did my 5spd swap was a Luk;it would slowly loose pressure and eventually stall of take off on me.....Second was a duralast mayb about 3 months old and it started doing the same thing to me as the Luk....except it was leaking the fluid by my pedal inside....So i went to honda and ordered both the Master and the Slave....i got em both on but i cant get any pressure.....took my whole line out....blew air thru it with my compressor and its not clogged.....i would pump and pump but the MC wont push the fluid into the line....would you guys think this can b a faulty MC honda gave me??

 

[2002CG3coupe]

Its possible they might or you still have air in there (look I rhymed but seriously ) or even maybe your clutch line might have been damage or has a whole and it leaking somewhere along the line.
I'm just curious are you bleed the clutch with another person or by yourself?

 

[BkzTafetta]

i took my whole line off (oem honda line) and blew air through it with my compressor and there are no holes or leaks anywhere on there....i plug the opp side with my finger and the air returns back from where im blowing meaning theres no holes....im bleeding it with another person....also i pump 10 ten times and leave the pedal on the floor and only air comes out.....yea i thought it was air as well but the reservoir tank is not emptying out as if the MC isnt pumping or sucking any fluid in....its hard to believe an oem honda MC is Defective and the worst part is that its not returnable, hopefully exchangeable....