DIY Smoked Tailights

[itswillie]

outer/brake lights are three 7 or 8 mm bolts with 3 electrical sockets each to disconnect. inner lights are 10 mms and 2 electrical sockets each. the trunk latch will need to come off, then just pop them out.

 

[CG6Lemon]

Um.. so all i do is take lights off. Then spray them with the can and then i spray a clear coat over it and im done?

 

[JMillerUA6]

outer/brake lights are three 7 or 8 mm bolts with 3 electrical sockets each to disconnect. inner lights are 10 mms and 2 electrical sockets each. the trunk latch will need to come off, then just pop them out.

All the nuts are the same size.

 

[itswillie]

All the nuts are the same size.

i definitely switched sockets on the ratchet halfway through. there's at least 2 bolts that were 10

 

[CG6Lemon]

can some1 answer my question please? Im really trying to do it asap. =]

 

[BadgerType]

Um.. so all i do is take lights off. Then spray them with the can and then i spray a clear coat over it and im done?

basically, but you gotta do it right to make it look damn good

 

[CG6Lemon]

Wut if it comes out bad or its not the way i want it? What do i use to remove the spray?

 

[BadgerType]

Wut if it comes out bad or its not the way i want it? What do i use to remove the spray?

wetsand



lots and lots of wet sand

 

[CG6Lemon]

lol thx for replying and OH NO! =[

 

[steadypimpin]

Wut if it comes out bad or its not the way i want it? What do i use to remove the spray?

i used this stuff called goof off, screw sanding thats too much work.

You dont need to take off the latch on the coupe btw.