eibach 23mm rear sway bar

[gt58]

The allen key goes from the inside, where the nut is. You will find that the bolt/stud has a grove on it for the allen key.

wow does this mean i'll have to use a wrench and cant use my socket huh. damnnnn.

as for the jackstands i knew about those 4 i was just wondering if there were any more jack points past that. i'll probably end up doing the install monday or tuesday because it is finals week and i really should be studying lol

 

[001Stunna]

wow does this mean i'll have to use a wrench and cant use my socket huh. damnnnn.

as for the jackstands i knew about those 4 i was just wondering if there were any more jack points past that. i'll probably end up doing the install monday or tuesday because it is finals week and i really should be studying lol

gear wrenches FTW =P

 

[gt58]

i need some of these

 

[001Stunna]

i need some of these

http://www.harborfreight.com/6-piece-metric-color-combo-wrench-set-66054-1746.html

 

[gt58]

i was there a few weeks back picking up some tools for my pocketbike and i scoped those out. they had some really nice ones. but my same buddy who has the jack and stands has every one so i'll probably see if i can use his tools lol

 

[gt58]

did the sway bar and all i have to say is holy ****. its worth every penny without a doubt. the install wasnt too bad. the hardest part was the back right bushing mount. it was difficult because the axle back was right there blocking the way. because i didnt have a gear wrench i had to turn it 1/4 turn every time and lift up and repeat. very annoying!! total install took about an hour and a half, i bet we could do it in 30 minutes if i did another.

i used the lower control arms to hold the allen key so all i had to do was wrench the bolt off the end links.

 

[gt58]

size difference

the 12mm bolt was a ***** to remove and put back on because of its proximity to the exhaust piping (where the b pipe meets the axle back)

 

[gt58]

took it around the block/freeway on-ramps..... loving every bit of it. i can grip so much harder, the front wheels dont chirp and slide out. cant freaking wait til i get coils

 

[001Stunna]

took it around the block/freeway on-ramps..... loving every bit of it. i can grip so much harder, the front wheels dont chirp and slide out. cant freaking wait til i get coils

lolz i bet it feels even better knowing you did it yourself =P. good job.

only thing i'll add is that you might start hearing a squeak from the back. if you do, take the sway bar brackets off, take the bushings off and add some Teflon tape around the area where the bushing goes on the sway bar. On top of the Teflon tape add some general grease along with greasing the inside of the bushing. Then just re-install bushing/brackets.

In my case only one side squeaked but I did the above mentioned to both sides anyways.

 

[99accord boi]

took it around the block/freeway on-ramps..... loving every bit of it. i can grip so much harder, the front wheels dont chirp and slide out. cant freaking wait til i get coils

nice hmu if ur ever down to go to the canyon
im about to pick one up ffor my car but i have the tl 6spd which is 19mm solid i believe on my car atm