hi flow cat question

[accordpowa]

Hey I'm new to 6gen and I have a question about the obx hi flow cat. I have a fujita CAI, 4-2-1 megan racing header, and 2.5 inch JDM catback exhaust. I was wondering if i installed the obx hi flow cat if I would gain a little power or lose a little power due to lack of back pressure. I have also been considering a test pipe any suggestions on what I should do? Anyone have any videos of hi flow cats or test pipes on there cars?

 

[mkdb89-02se]

not really get magna flow by tha way obx is ok for cat back and all but cat in our cars are pretty sesantitive,,,

 

[turboaccord98]

The OBX "highflow cat" is actually just a resonated test pipe. I have it. So dont expect to get an actual catalytic converter. Mine also did not come with a bung in it for the o2 sensor so keep that in mind.

 

[mkdb89-02se]

bung? im not even sure what u mean, in the end u get what u pay for

 

[turboaccord98]

A bung is the threaded hole in the side of the cat/test pipe, where you install the o2 sensor.

 

[Vomit_Comit]

The OBX "highflow cat" is actually just a resonated test pipe. I have it. So dont expect to get an actual catalytic converter. Mine also did not come with a bung in it for the o2 sensor so keep that in mind.

so your check engine light is on?

 

[accordpowa]

this is the obx one i was looking at http://cgi.ebay.com/ebaymotors/OBX-...ptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

 

[mkdb89-02se]

if its on punch a hole thro tha cat and put a defouler in and it will be 20 bucks cheaper than obx, plus code will go away, the obx cant do that

 

[Vomit_Comit]

i want a test pipe. will it make a ws1 cat back louder a little

 

[mkdb89-02se]

i got a test pipe ill sell to u 20 bucks