White6GAV6
Well-Known Member
Good update. Hopefully it goes a little quicker from here on out, without any troubles. Interested to see final product and price of a kit.
Interest In Custom Rear Control Arms
- Thread starter Sleeper Cell
- Start date
Sleeper Cell
No more CG Squad!!!
Schematics were submitted for review by the manufacturer. We're hoping to have a tangible product by February to test and begin selling.
White6GAV6
Well-Known Member
Hmm should be good time as to when I'll probably be needed camber kits. I just ordered some for the front but they max is only -2 addition degrees. I'm kind of think I want more. We should get some custom front arms or ball joints made haha
Sleeper Cell
No more CG Squad!!!
That may be a possibility as well, although I do not have any additional arms to compare them to up front. I'm running the OEM stuff up there since I've never needed to add more camber, and my toe has been behaving a bit more up front.
White6GAV6
Well-Known Member
Idk what else could be done for the front to add more camber. I'm at like -3.5 or something up front right now, naturally. So with the kit I can get to like -5.5 max. I want to shoot for like -7 or -8 though. Not sure if a custom ball joint could be made to achieve that or if the full control arm would have to be made.
Sleeper Cell
No more CG Squad!!!
Just curious, why do you want so much negative camber? lol
White6GAV6
Well-Known Member
Lol, good question. I want to try to run 11s all around. Not even sure if it's possible, but if it is, might as well give it a shot.
Sleeper Cell
No more CG Squad!!!
11s up front are easier than 11s in the rear. You have a lot of inner clearance up front.
White6GAV6
Well-Known Member
I've been looking at the 18x11 +7 VS-XX. I know that's super aggressive but I like trying things other people haven't. You think there woul be enough clearance for those specs and that much camber?
