Quick answer H22 Swap

[dv8801]

Im doing a swap as I'm writing this. Can I use the H22 harness instead of the f23?

 

[jdmcg3]

as long as you rewire the h harness to the right pin outs for the fuse box pigtail.

and you should make a thread for your swap. remember to take lots of pictures.

 

[dv8801]

Thanks. Any write ups for the pin outs anywhere. I will do a thread when I do my swap. This is a quick swap for a friend of mine

 

[2002CG3coupe]

Stick with f23 harness it will be easier seeing it almost a direct swap some pin will need changing but there's nothing soldering also depending if it a jdm motor you'll need to extended the wire from the crank to the dizzy

if it a usdm the green wire from the H22A4 distributor (ICM) should be hooked into the ground side of your MSD coil primary winding. That is the signal from the ICM to fire the coil. The BLK/YEL 12v wire is the feed for the coil (+). The blue wire is your tach & TCU(M) signal. honda-tech ref..

 

[jdmcg3]

Stick with f23 harness it will be easier seeing it almost a direct swap some pin will need changing but there's nothing soldering also depending if it a jdm motor you'll need to extended the wire from the crank to the dizzy

if it a usdm the green wire from the H22A4 distributor (ICM) should be hooked into the ground side of your MSD coil primary winding. That is the signal from the ICM to fire the coil. The BLK/YEL 12v wire is the feed for the coil (+). The blue wire is your tach & TCU(M) signal. honda-tech ref..

^ i believe theres alot more to it than just that. im pretty sure Drift had to do a bunch of stuff. i may be wrong though cuase i havent read that thread in a while. but if you could drop the link where you got that from off honda-tech that would be great.


OP.. as far as write up go.. i dont know of any. but ill try and make one tomorrow. if i do.. ill PM you the link

 

[2002CG3coupe]

For usdm h22a4 dizzy pinout
http://ht-archive.org/showpost.php?p=44548562&postcount=31

 

[jdmcg3]

damn you responded to that hella quick lol.. but thats only for wiring up the dizzy.

OP read this. it may help. http://www.6thgenaccord.com/forums/showthread.php?t=27142

 

[2002CG3coupe]

Just finish writing up an assignment was bored came to 6ga lol

 

[dv8801]

Thanks for all feedback. I'm using all links provided

 

[Ocho]

as long as you rewire the h harness to the right pin outs for the fuse box pigtail.

and you should make a thread for your swap. remember to take lots of pictures.

i dont understand this ^ why is it easier to swap in a civic than the accord?
im doing the swap too, cant i just get the whole fuse box and sub harness to wire it plug and play into the accord? 6thgen course..