Tightening mood end links? HELP

[PhattyT]

Well... i did everything so far, install new rear sway bar, but i can't seem to screw in the moog end links... the screw keeps turning after a certain point. This might be a simple question for most of you but i've searched and had no luck.

Thank you.

 

[LX_F23A1]

Take a flat open end wrench ( 14mm ) and stick it into that ruber protective ball and you will find a nut, hold that nut, and twist the nut by the endlink.


and thats what she said

 

[1NonlyAccord]

on my moog endlink the nut was visible before the boot..
but yea just hold it with the corresponding wrench...^

 

[LX_F23A1]

its been a while since i looked at my endlinks, but yea i belive it sticks out, its visible.

 

[PhattyT]

awesome! thanks! and what are the little screws for?

 

[F23A1AT]

awesome! thanks! and what are the little screws for?

Those should be the grease fittings They would be easier to put on before the link goes on the car. I put one on the front this morning.

 

[PhattyT]

oh ok, i just put them on... are the ball joints suppose to be move-able? roll around n stuff?

 

[F23A1AT]

oh ok, i just put them on... are the ball joints suppose to be move-able? roll around n stuff?

Yeah, but not fluidly.