YoungxNutkase
Well-Known Member
1ST question pretty simple, i was wondering how i would remove the black trim right before your gauges (right above the steering wheel). I know theres two screws on the top, which i remove i pulled it and the bottom still a lil stuck, so i dont want to break it. So i rather be safe and ask u guys 1st before i pull it out....the diy for this im doing its painting it to match the exterior of my car
2nd question, carbon fiber question... i have carbon fiber splitters that i banged up and got alot of the clear coat scratch off. So i was thinking to add a couple coats of clear on it... i was just wondering should i sand off all the remaining clear coat off?? and if i do sand it off will it ruin the carbon fiber?? i was just going spray the clear coat on but that scratches and chips would still be seen right under the new coat of clear...so im unsure of sanding the clear dont want to rip or mess up the carbon fibers
2nd question, carbon fiber question... i have carbon fiber splitters that i banged up and got alot of the clear coat scratch off. So i was thinking to add a couple coats of clear on it... i was just wondering should i sand off all the remaining clear coat off?? and if i do sand it off will it ruin the carbon fiber?? i was just going spray the clear coat on but that scratches and chips would still be seen right under the new coat of clear...so im unsure of sanding the clear dont want to rip or mess up the carbon fibers