cutting fender lip?

[1NonlyAccord]

I like the way my tire sits,but today once driving it when i hit bumps i hear scrapping My guess is its the lip/tabs in the fender.

I know its suppose to be rolled but can i just cut it off instead?
mayb even cut the quarter panel lip..
best pics i can get..

 

[david5788]

yea you can get a grinder in there and take it off. i believe Kevin (UnIQuEX) grinded his off.

 

[swollen_cu]

you can cut it, but be sure to smooth ir out as much as possible. You dont the sharp edges to cut your tires. Or you could just add some negative camber to it.

 

[1NonlyAccord]

ya i was thinking about it being sharp afterward..ill use my zizwheel and then angle grinder to smooth it down. I just didnt know if anyone just cut it off instead of rolled it back.

 

[LitoCG2Rider]

i cut my rear fenders...i like it better then rolling the fenders and relocate the tabs lik most of the member on her does

 

[1NonlyAccord]

well i dont have fender liner,so i have no need for the tabs.

 

[swollen_cu]

well i dont have fender liner,so i have no need for the tabs.

hows your camber? stock settings? if not, just add a little bit of negative camber, and you'll be set!

 

[Sakuradrops808B]

Better way is to just roll them imho.

 

[swollen_cu]

Better way is to just roll them imho.

+1! thats what i did with my fenders. I own a fender roller, so it was easy. You just have to be careful when rolling them. Use a heat gun and heat up the paint before and during rolling. This is to prevent the paint from cracking or from the metal deforming.

 

[1NonlyAccord]

hows your camber? stock settings? if not, just add a little bit of negative camber, and you'll be set!

ya its just the camber from lowering it that much..how do i give it more?

Better way is to just roll them imho.

i know thats better to keep that rolled edge,but i have the tools to cut it off in 5secs..