Recent content by accordmatt

  1. A

    brake issue

    i wanna lean towards clips because of how it sounds. but ive removed them n check over everything i will have to try to manually turn while someone breaks hopefully that will find it
  2. A

    brake issue

    no air in lines and fluid level is fine. its something binding up the round center of rotor has a fresh metal scrap but l dont see anything scrapping it
  3. A

    brake issue

    ok so l just replaced broke wheel studs. afterwards when l brake it stops to slow and then slips at last min. i have to left off brake then hit it again to stop. i also do hear a small grinding noise when this happens. i just replaced the brake pads, filed down rotors. ive taken them off and...
  4. A

    6th gen accord h22 swap OBD2 fan wont turn on:(!

    bad fans
  5. A

    stereo harness for 5th gen work on 6th gen?

    ok so i pulled all the bs outta there and found the stock connector. yay so l rewired them all back to it. now im off to get the correct harness only took me about 5 hrs of straight pulling panels and pulling all the wires and cords out for unneeded ****. so it better work after all that
  6. A

    stereo harness for 5th gen work on 6th gen?

    thought so thats for the confirm. im inside of the worst wiring job ever. 6 cd changer wired in, along with a old *** nokia phone dock and speakerphone system. half the wires are soldered and half are twisted with electrical tape. well see how it goes:furious:
  7. A

    stereo harness for 5th gen work on 6th gen?

    i have these i went to junkyard they had no 6th gens. there is no connector on my factory harness it was cut off. thats why l wanna try this
  8. A

    stereo harness for 5th gen work on 6th gen?

    ok so my 2000 accord factory harness was butchered by prev. owner. They cut off factory harness connector and hard wired pioneer deck, instead of just using a wire harness. i dont wanna just hard wire my deck in to replace it. So i do have both ends of a 5th gen accord harness. Will this wire up...
  9. A

    1996 Honda Accord 4cylinder engine swap.

    hondasociety.com x 2
  10. A

    Dirty South,NC checking in

    sorry bad storms n rain delaying pics all week probally. but heres some of my cd5 swap for incentive
  11. A

    Dirty South,NC checking in

    Thank You everyone will post pics asap. basically stock I/H/E Rims staying on cd5 till l run these brand new tires out. i need to do something with the stock rims
  12. A

    Console Lights/Bad rings?

    ok ive looked and looked my ash tray lights out and my gear shift selector light is out. P R D4 D3 2 1 dont light up. i have 202,500miles just redid head and timing belt. piston rings are going bad. blowing blue smoke,burning oil. ive used lucus it helps. and tried risilone compression...
  13. A

    Unknown leak, need fixed by Monday!

    sounds like a hole in a hose. most likely PS
  14. A

    Dirty South,NC checking in

    Not a newbie to the accords by any means. ive owned my 96 cd5 since 17. well put a hole in block of that h22. so my dad hooked me up and gave me a 2000 f23a4 accord for $500. paid for the tires/shocks and struts. of course my luck when he was driving to his house to load it on trailer and a...
  15. A

    New here Old to game

    Hey im Matt i am the owner of a 96 Accord 2000 Accord ive owned my 5th gen for over 10 yrs. ive currently did a JDM h22 swap auto-5speed swap I/H/E SRI Exedy clutch Cross-drilled/Slotted Rotors SS brake lines Esp motor mounts Etc. Etc lots more. my 6th gen has I/H/E more to come
See more

Latest posts

Random media

2140.jpg
011
Roof is plasti dipped flat black
SOHC VTEC Decal
rear...chrome exhaust, 6GA decal, and VTEC decal almost visible
Back
Top