Recent content by lmayoral2191

  1. L

    F20b swap! After f23 blew up

    Street pulls coming soon, I’m still waiting on some last parts and have been working out some issues. But she is still in one piece at 6lbs, just waiting on the regulator to show up and dial in my fuel pressure and crank up the boost a bit. Videos coming soon!! Sorry for the huge delay
  2. L

    F20b swap! After f23 blew up

    The internals have nothing to do with the pistons blowing apart.. it’s the ignition timing that took out the piston. Pre det will take out a piston very easily even on a block with built internals. Stock internals can handle atleast 10lbs of boost with no problem and that’s daily driving...
  3. L

    F20b swap! After f23 blew up

    Alrighty then update time: My car has turned into a major pain in butt!! Okay so the first F20b engine blew up .. it blew up after the second pull on at 6psi. Cylinder 4 ringland blew apart. Fast forward 5 weeks, ordered a fresh f20b from hmo.. super excited and installed it within the next...
  4. L

    F20b swap! After f23 blew up

    Alright I’m in need of help!!! My engine feels gutless!!! Timing is on point, along with ignition timing. Anyone ever have this issue?? My tuner can’t figure it out
  5. L

    F20b swap! After f23 blew up

    On my previous setup I didn’t spin a rod bearing, the piston actually cracked. I’m assuming a ringland broke
  6. L

    F20b swap! After f23 blew up

    I like how I posted this and everyone thinks I’m gonna spin a bearing... does anyone know how to check clearances?? I’m sure I’ll blow a compression ring first but that’s what my water meth kit is gonna help reduce the chance off lol... thanks to the people that said good luck and cool swap...
  7. L

    F20b swap! After f23 blew up

    So 2 weeks ago I blew it up, finally everyone I knew said lol. So I had to rush to put my F20b swap together.. here’s a few pics of the engine on the engine stand ( the block was bare bone when I blew up my accord lol ) https://drive.google.com/open?id=12sso1R11iZHpWpLUd6gcF_5cPw430LJC...
  8. L

    F20b swap! After f23 blew up

    Thanks man I like that app a lot better then photo bucket! Alright so I’ve driven my accord roughly 4yrs and it’s been boosted for about 2 out of the 4. I decided too boost a 260k mile engine as trial to see how much can this engine can handle! I started out with 4lbs, handles great no...
  9. L

    F20b swap! After f23 blew up

    Alright my swap is nearly done, I would like to share pics with you guys but don’t know how to upload them? What do I use to upload them ( mobile device )
  10. L

    Exhaust system help

    I bought a ebay catback and cut off the fat cannon and put on a vibrant street power muffler with a 12” vibrant resonator and it sounds great. Deep sound and not terrible on the highway at 80
  11. L

    Question for my f20b swapped people

    I figured it out No more cyp issue
  12. L

    Question for my f20b swapped people

    I’ve looked and pinouts for the accord but I can’t find any for the f20B distributor pin out. Vehicle starts up and runs, just throwing a CEL for that code. Driving me nuts lol
  13. L

    Question for my f20b swapped people

    I’m working on the distributor wiring right now, I’ve extended the wires from the ckp to the new distributor connector. My question is there is 9 wires on my f20b plug in, I only have 8 on my factory accord harness. I keep getting a code 9 on Hondata for cyp... anyone ever dealed with this issue?
  14. L

    p28 conversion with hondata s300

    I currently run my car on hondata s300, I just needed too get a jumper harness from obd2b to obd1. I do have a iac issue because my iac is a 3wire and the s300 requires a 2 wire. I have no issues with my hondata, my tuner was able to get my car tuned on 10lbs without a problem. Also hooked up...
  15. L

    FMU topic

    I know I have to upgrade map sensor once I wanna crank up the boost and also the fuel pump and injectors. As for the fmu I gave it a shot since I ordered it.... Now this is were the horror begins. The thing was built incorrectly, at idle it was backflowing my injectors making me run 10.1 at...
See more

Latest posts

Random media

smoked taillights,should i do the center too or what,help!
Old Sub install. Front firing IDMax 12v3d2 off of about 450wrms from a Nine.1
Back when it had 18's
Accord
goin low
Back
Top