I have a decent singing/humming from the Front Passenger side. had a wheel bearing done on the driver's side a while back and thought I'd been duped on which side the noise is coming from. Finally pulled over to take a gander behind the knuckle not expecting to see anything and there was grease...
I'm at the point of needing to do an axel and am curious if anyone knows if it is possible to do without separating either upper/lower ball joint (contrary to the Haynes manual). Don't have the tools handy to free the knuckle up and would like to just lift the car, remove the nut, push & pry the...
Better question:
Has anyone ever successfully fitted these into a '98-'00 bumper? The existing space seems quite generous, should require minimal cutting. If anyone knows if and where some technical drawings can be found, that would be badass!:bowdown:
This may seem like a dumbass question, but what is the difference in fog light fit between the coupe and 4-door bumpers? (1998) My searching has turned up no specific information on this yet but a thread MUST exist somewhere!
I'm hoping to buy an eBay fog light kit...
Long overdue update:
I have since replaced the outer pass. side tie rod which did silence some of the noise. The car was in to a small local shop when a similar noise persisted. there was no movement on the hoist, but when the suspension was loaded up, some play was found in the sway bar and...
If anyone has ever seen a cutout/shape of a 6gen coupe rear window upper brake light and could post a link, that'd be sweeeeet. I'm cutting a Hawk sticker to cover the rear light (have an adequate third brake light in the spoiler so might as well have fun with the other one) that will illuminate...
I've owned my 98 coupe for two years now and suspension wise have only installed an upper driver's side OE control arm. The passenger's side was slightly dismantled when I installed a new clutch about 16 months ago.
There is a noticeable clunk if I can cause a jounce against driveline torque...