The brand is "Sloop"
Made in Taiwan lol. They look and feel very sturdy.
Lets see how they hold up, I feel confident they'll do the job
305S0L's 2002 Black Coupe EX
- Thread starter 305S0L
- Start date
The brand is "Sloop"
Made in Taiwan lol. They look and feel very sturdy.
Lets see how they hold up, I feel confident they'll do the job
RedRyder
Save the manuals
Yeah post a review in the product review section after you've had them on for a bit. I've been looking for an alternative to Moog, the inner nuts always strip.
I don't see an inner nut to hold with an open ended wrench while you turn the outer nut to tighten it down...? Or am I just not looking at it correctly?
I don't see an inner nut to hold with an open ended wrench while you turn the outer nut to tighten it down...? Or am I just not looking at it correctly?
Trippinsolzz
Well-Known Member
Where'd you get your wheels ? I want some just like that really though how much did you spend ?
Mr. C
Mr. C
Will do Red. I considered Moog but went with these because I found them locally on ebay. Bought on Monday, installed on Wednesday.
I think you are correct with your observation. To install I just popped the endlink in and tighten the outer nut with the impact gun carefully. I also used my floor jack to push the lower control arm slightly upwards to get a proper seat for the endlink ends.
I didnt even notice an inner nut. To me, they looked just like oem, and I didnt notice an inner nut on the oem ones. I used a vice grip on one side and the impact on the other to remove. oh, and lots of penetrating oil & a heat gun
Thank you! I bought them off Ebay. I believe they were around $550
RedRyder
Save the manuals
I'd grab that 2G TL OEM sides/rear then sell it for a profit.
Considered it Red, but the margin for profit on used parts is so low IMO. How much are these things going for now?
