350 block

[dvilla5506]

I know anything is possible but wat wud make it possible to drop in a 350 block into the accord...like ecu and wires wise I like the fact that most muscle cars have a really open engine bay and most japanese cars seem to take every inch of the engine bay up......comments criticism or watever u got to say is welcome

 

[finch13]

Way out of your league if you're even asking.

You'd need to fab custom mounts, build a larger driveshaft tunnel, grab the wiring harness, upgrade the suspension to hold that much weight. Depending on the 350, figure out how to integrate a few control modules. Figure out how to tranform the rear independent suspension to leaf spring, etc. etc.

 

[Mike's_Taffeta]

Anything is possible. They have a v8 kit for a ford focus. And you don't have to convert to leaf springs unless you wanna an out of date suspension set up.

 

[Vlad02coupe]

keep doin your homework on this.. and if your seriously thinkin about it i cannot wait to see pics lol

 

[nyknick1015]

It actually is possible to fit the 350 block into an accord... in reality, its not that hard because the engine is not that big... Custom mounts are almost NO problem... the only problem that makes this swap near impossible is the transmission

There is NOT A SNOWBALLS CHANCE IN HELL that ur gonna fit that tranny in the accord with out cutting out the entire firewall and floor of the accord.... even if you do, look how far back its gonna push the shifter. Shifter is gonna be in the back seat lol

 

[dvilla5506]

lol that tranny is huge it was just a thought

 

[shavedaccord]

it's been done to a 4th gen

 

[finch13]

And you don't have to convert to leaf springs unless you wanna an out of date suspension set up.

Oh yeah? What rear end were you thinking of? All of the fun ones had leaf springs.

It actually is possible to fit the 350 block into an accord... in reality, its not that hard because the engine is not that big... Custom mounts are almost NO problem... the only problem that makes this swap near impossible is the transmission

There is NOT A SNOWBALLS CHANCE IN HELL that ur gonna fit that tranny in the accord with out cutting out the entire firewall and floor of the accord.... even if you do, look how far back its gonna push the shifter. Shifter is gonna be in the back seat lol

Jesus, what tranny is that? A 4L60-E wouldn't be too bad and definitely not as long.

 

[Mike's_Taffeta]

http://www.kugelkomponents.com/focus/focus.html

Take a look at this. Doesn't look like they're using leaf spring to me.

 

[dvilla5506]

OT ^^^ did u do somethin different to ur car