98CG5
Active Member
Hey guys, I just replaced my axle seal on my Sedan and I noticed that when I was putting the new seal in, it went in rather easily, almost like it was too small. Well, after I installed everything, I started the car and put it in drive(while on jackstands), and the trans was leaking from the new seal.
Now, the new seal has a copper rounding. Im assuming a after a heat cycle the seal will expand? I cleaned everything to make sure the surface had no debris during reinstallation. Should I go to a Honda Dealer and get a seal from Honda?
Now, the new seal has a copper rounding. Im assuming a after a heat cycle the seal will expand? I cleaned everything to make sure the surface had no debris during reinstallation. Should I go to a Honda Dealer and get a seal from Honda?