Battery Tie Down

[Bax]

Yup.

I've forgotten about this, because I've gotten too used to it....but my battery has always been held in place by a bungee cable. This is due to whatever the people before me did.

So I figure, someone on here has to have gotten a new aftermarket battery tie down and has the old stock one laying around. Well, I'll buy it from you.

I just want the top metal piece. I can order the bolts from Honda, but if you have a spare set of those, then that's even better. Not necessary, though.

So let me know.

 

[LowerMyCG5]

bolts tou can get from autozone, get a aftermarket one !!

 

[Bax]

Autozone has the bolts I need?

Idk about aftermarket, most of them I see are flat pieces. The oem one is curved in the middle right? My battery isn't flat on the top, so if I get a flat one I think it will look weird. Plus I don't want to spend too much money. I just want to take someone's old oem one off of their hands.

 

[LowerMyCG5]

yea they should. and check EBBBAAAAY

 

[Bax]

All I can find on egay are the aftermarket ones. I don't want anything "aftermarket" on my battery... my battery isn't worth drawing attention to. lol
I just think the cable holding it down looks stupid as ****.

 

[LowerMyCG5]

the polished one on ebay looks clean. you could try tasauto

 

[Bax]

I found the rods on Tasauto, http://www.tasauto.com/Product/Detail.aspx?s=2831515&d=1308&p=1

But they're cheaper here: http://www.hondaautomotiveparts.com...4DR+LXV6&catcgry4=KA4AT&catcgry5=BATTERY+(V6)
Roughly 7 bucks for rods and nuts.

I just need the tie bar. -__-
And yes, I know I can get one from HondaAutomotiveParts from the link above. But I don't feel like paying over ten bucks for a piece of metal...

 

[nhldogg]

http://www.6thgenaccord.com/forums/showthread.php?t=35721

 

[Bax]

I just want the stock one. I don't want anything flashy on my battery. My engine bay isn't for show at all, I just want the stock tie bar. Thanks though.

 

[JDM_Rook]

I have a stock battery tie down bar and one tie down bolt. The shorter of the two bolts. The bar has a couple flaws. The plastic coating is barely peeled in a couple spots. And some light battery acid chalk. You can have it free. Just pay shipping.

Bolt is new, never used from TasAuto. PM if you're interested.