Best turbo for my setup?

[9450erick]

Did you know ball bearing center cartridges where designed for the longevity of a turbo, with a side effect was a tad quicker spooling.

Look for a Billet wheel turbo, they give the big turbo power in a small turbo housing, and are excellent on spool time.

Also know that you cant have both, quick spool and top end. You just have to find that happy medium.

there has to be a middle/ interested in the who makes the billet wheel turbo in a small frame?

Those 450cc injectors are too small for any of the turbos you listed.

i know im planin on runnin 1000cc rc injectors/ fixed 1st post

Well actually, you need your car to spool early because of our limited rpm range and longer gear ratios.

thats what i want to spool fairly quick but make great top end

I'm using a .57 trim and I start getting close to full boost by 3800rpm when vtec kicks in and its great at top end.

and which turbo r u runnin? is it a secret? lol

 

[9450erick]

wouldnt it be great if they made 9:3:1 forged pistons for our car
i think that would make life so much easier and be a lot cheaper lol

 

[9450erick]

i think this is a suitable turbo for my build
http://www.timsturbos.com/S256PL.html
http://www.cimotorsports.net/motor-sport-products/bullseye-power-t3-s256-turbocharger.html
what do you guys think?

 

[1NonlyAccord]

why not spend 575$ on a garret? Im going to be running the 60trim .48exhaust A/R.
its supported up to 475whp and produces 53 lbs/min 678cfm.

or even same price for the 57trim with .48/.63 exhaust A/R.

and just a little insight,my 150$ T3 ebay turbo .50trim with .63AR is putting me at 217whp and 238wtq without any tune or proper engine management at the time being..ha

 

[9450erick]

i would get a garrett but those from what i heard seem to fail after a couple of years.
now with borg warner i havent heard anything bad about it/ only positive things and ive been researching through the ***
thanks though for helpin out/ if there is a great deal on a garrett i might just jump on it

 

[1NonlyAccord]

me ebay turbo is still going fine after 3+years..haha but What ever suits your setup best.

 

[Erik123456789]

the ebay turbo is only good for low boost applications, they dont start to mess up until after 12-14psi

 

[9450erick]

since i want to start with crome/450cc injectors i want a turbo that can perform well in low boost and high boost since later im going to run hondata and 1000cc id injectors and maybe get custom pistons