custom exhaust

[MikeyMike]

headers - high flow magnaflow cat - 2.75" piping - 18" long 3" magnaflow resonator - more 2.75" piping - single 3" magnaflow muffler

result. Deep low rpm tone, virtually quiet while cruising.. powerful tone when hard accelerate

http://www.youtube.com/watch?v=dqZ0pizzspY

http://www.youtube.com/watch?v=PjTnLSTQjcI

 

[4NDR3W_6THG3N]

headers - high flow magnaflow cat - 2.75" piping - 18" long 3" magnaflow resonator - more 2.75" piping - single 3" magnaflow muffler

result. Deep low rpm tone, virtually quiet while cruising.. powerful tone when hard accelerate

http://www.youtube.com/watch?v=dqZ0pizzspY

http://www.youtube.com/watch?v=PjTnLSTQjcI

^This is a perfect exhaust!

 

[maddmatt02]

I have a I4-stock manifold-no cat-2.5 (I think, dont remember anymore)- 18" resonator (glasspack, again not sure on the length, Ill check that as well)- flowmaster 40.


not really the same setup at all, but I have videos of it from in the car I think, and I know I have a couple fly by's I can try and round up and post tomorrow if you want.


*edit* I guess I already had them uploaded. "exhaust 5" isnt really a fly by because the road was pretty windy, and I wasnt that far away from where the cops might be so I had to let off even before I got all the way to the camera.

http://www.youtube.com/watch?v=FQDWyhOJriU

http://www.youtube.com/watch?v=zAFJObEHfeo

http://www.youtube.com/watch?v=DeQhPUiTvNU

 

[atvfreak19902]

welll its done, i like how it came out. its loud... i wanted to upload a vid today, but my camera is missing.

 

[732xghost]

a recommendation if i may.

as you stated you already have headers. i recommend 2.5" piping from a high-flow cat back with no resonators into CL-S or TSX mufflers.

very stealth, clean, and you'll still feel some gains.

 

[02J4accord]

It would think your system would sound good.
Ill be replacing my exhaust set up now (2.25 piping to dual offset OBX mufflers) with a custom exhaust within the month. Goin with 2.5" piping from my existing 4-2-1 hearder to test pipe cat. Then a 30" magnaflow glasspack for my resonator into a dual out 2.25" flowmaster 10 series right before the rear axle. The flowmaster is just basically for a split and a little tone being that it will not muffle much. If i fine that it is to loud I will put 18" magnaflows on each side before the tips. I havent seen this done before so I figured id try it out to be a little different. Hope i dont come to regret it. Im just getting anoid with the drone of what i have now.
I have allready purchased the mufflers and tips, just waiting to be installed.