Red is Dead
Car isn’t the cleanest but I don’t really care lol. It will be eventually , as soon as I stop blowing up motors. A lot of people probably read my 5 speed swap story and had a good laugh at my expense. All good lol. For those who didn't, I basically didn't fully bleed the clutch and drove through the garage door lol. So here's my 6th gen. Got it for 300 dollars with a failing auto trans. Since I did my first oil change I've spent almost all my money getting this car healthy again.
Engine: F23a4 ULEV [Dead]
H23a1 from 94 Prelude SI [Dead]
Current: F20b with Ms24 prelude manual transmission.
Engine parts:
* JDM F20b
* Spectre cold air intake
* Spectre valve cover vent filter
* Denso radiator cap
* NGK iridium spark plugs
* OEM spark plug wires
* innovative H swap mounts
Transmission:
*MS24 Manual Transmission
* Oem Flywheel
* Oem throw out bearing
* Oem clutch disc
* Excedy clutch slave cylinder
* Duralast clutch master cylinder
* Cardone drivers side half shaft
* Cardone passenger side axle
Brakes:
* Raybestos front rotors
* Raybestos ceramic brake pads
* Raybestos rear drum shoes
* Raybestos rear brake cylinder (right)
Cosmetics:
* Front bumper stitches
* 95 Toyota Camry wing
* Avs wind visors (sides)
* [COLOR=“red”]Spec D tuning headlights[/COLOR]
* Oem headlights
* 2012 TL Modified wheel wheel liners
* 2015 Accord oem fog lights (5/25/17)
* eBay front lip
* 2017 accord under carriage splash guard
Suspension & Handling:
* Truhart lowering struts
* Megan Racing lowering springs
* Moog front sway bar links
* Moog outer tie rod ends
* Moog upper control arm w/ball joint (right)
* Moog sway bar link bushings
* Acura TL Strut Bar
Exhaust:
* Ebay Header and DC Sports downpipe
* Flowmaster universal high flow cat
* Exhaust pipe scavenged from another car(Frankenstein exhaust lol)
* Flowmaster 40 series muffler
Interior:
* OEM Coupe front black leather seats
* 2001 Acura TL black leather rear seats
* Window tint
* Black coupe steering wheel
* manual 99 accord brake pedal
* manual 99 accord clutch pedal
* 04 civic si shift knob
* Chipped P28 Ecu with custom OBD1 jumper /Disabled IACV and 2step launch control/
* "Custom" center console charging hub
* Aux cable routed under console to inside center console
* Sylvania zevo LED door bulbs (6418)
* Sylvania Zevo LED Dome light
* OEM Leather Shift boot
Wheels:
Plastidipped white NS 15 inch wheels
Tires:
Primewell valera sport AS 195/50/15
Fluids:
* Honda genuine manual transmission fluid
* Mobil 1 High Mileage 5w30 motor oil
* Rain X windshield washer fluid
* Valvoline DOT 3 brake fluid (clutch & brake)
* Prestone 50/50 antifreeze
* Honda genuine power steering fluid
Maintenance:
A lot was performed recently
Drivetrain:
* Driver's side axle (186,XXX)
* Passengers side axle (186,XXX)
* Clutch installed (186,XXX)
* Driver's side wheel hub (184,XXX)
Engine:
* Heater core coolant hose (171,XXX)
* Oil change (172,XXX)
* Intake manifold deep cleaned (174,XXX) (not fun)
* Rocker arms and shaft cleaned (174,XXX) (definitely not fun)
* Oil pan gasket replaced (179,XXX)
* Oil change (180,XXX)
* Coolant flush (184,XXX)
* Valve cover replaced(185,XXX)
* Clutch fluid flush (186,XXX)
* Brake flush (186,XXX)
* Winshield wiper fluid fill (186,XXX)
* Engine bay deep cleaned by hand
http://www.6thgenaccord.com/forums/showthread.php?p=1095811
* H23a1 Swap (186,XXX)
* F20b Swap (70,XXX on motor) (187,XXX on chassis)
O-rings/Seals:
* Thermostat housing o ring (17X,XXX)
* Radiator drain plug o ring (180,XXX)
* Distributor inner seal (18X,XXX)
* Rear main seal(185,XXX)
* Vtec solenoid body o rings (185,XXX)
* Distributor shaft o ring (186,XXX)(5 times, ended up sealing with rtv, still leaking)
* Valve cover gasket (186,XXX)
* Drivers side axle seal (186,XXX)
Body and chassis:
* Lower control arm (18X,XXX) (right)(bent)
* Upper control arm w/ball joint (18X,XXX) (right)
* Hood (182,XXX)
* Drivers side mirror(182,XXX)
* Subframe (18X,XXX)
* New Windshield (Front)
* Front sway bar links (18X,XXX)
* Front tie rod ends (186,XXX)
* Front and rear sway bar link bushings (185,XXX)
* Front right lower ball joint (186,XXX)
* Front right sway bar link
* changed hood to correct model year
* added fender liners and splash guard
Electrical:
* ECT sensor (171,XXX)
* MAP sensor (173,XXX)
* Battery replacement (185,XXX)
* TPS sensor (186,XXX)
* VSS sensor (186,XXX)
* Fuel rail harness tuck (186XXX)
* Passenger side headlight, radiator, horn,AC compressor / condenser harness tuck (186,XXX)
* Battery tray removed (186,XXX)
* Battery moved http://www.6thgenaccord.com/forums/showthread.php?p=1095797
* TPS, vtec pressure switch, vtec solenoid, map and distributor harness tuck (186,XXX)
Interior:
* Cabin air filter (186,XXX)
Want to know anything? Just ask. Want me to do a thread on something? Just ask lol.
Ps: I added some funnies in the photos. Yes it fell off while I was driving.
Thanks to Richard aka Sil2DrV6 for the formatting idea and having one of the cleanest 6th gens around.
Attachments
Last edited: