talontsiawd
Well-Known Member
I shaved one of my valve covers a few years back. I ground most of it off, then used a belt sander to get it smooth. It looked good with paint, I swapped it awhile ago, have a little oil leak, considering going shaved.
I was thinking this one would look nice polished. I didn't have much of the coarser sand paper I need but I just started doing the basics to see how it would look. I quickly noticed that the raised letters still show up. I have tried many things but they will not go away. It's not close to being done, this was just to see how it would look but it's not coming out. Here is a pic:
Any advice on how to get rid of it or why it won't come off?
I was thinking this one would look nice polished. I didn't have much of the coarser sand paper I need but I just started doing the basics to see how it would look. I quickly noticed that the raised letters still show up. I have tried many things but they will not go away. It's not close to being done, this was just to see how it would look but it's not coming out. Here is a pic:
Any advice on how to get rid of it or why it won't come off?