Good place to roll fenders SOCAL!!

[Werkmeister47]

so yeah i just got my car back today, and since they completely replaced everything from the rear they put in a new bumper and i need to pull my bumper tabs, last time i did me and my friends did it the ghetto way(with a bat) this time i was wondering anybody here know a good shop in socal that you can refer me to? i live in the valley by burbank so i guess anywhere from burbank all the way to west covina i'll do, i know this is more of a local help for all the people in socal but thanks in advance

 

[MrLazie1]

i heard mazz autosport is okay. thats in like san gabriel-ish area. on las tunas.

 

[paypalbid]

get a bat and roll it your self. insert the bat underneath the wheel well and have a friend slowwwwly drive the car forward as the bat shaft sits between the tire and fender edge.

I did it and the bat has cuts on it but was a fine job. No paint chip

 

[Werkmeister47]

i did that last time with the bat and it didn't come out too good, my front is good it doesn't rub, but my rears rub, its also my bumper tabs they rub the wheel more than the fender, and i heard about mazz but i'm not sure if they're legit

 

[finch13]

i did that last time with the bat and it didn't come out too good, my front is good it doesn't rub, but my rears rub, its also my bumper tabs they rub the wheel more than the fender, and i heard about mazz but i'm not sure if they're legit

Just use a cutoff wheel and take the tabs off and see where it rubs after that. You should be able to see wear marks in the wheel well from the tires, my bumper tabs are the only thing worn down.

 

[nyknick1015]

you can rent a fender rolling kit from autozone... all you need is that and a hair dryer or heat gun

 

[inspired1]

you can rent a fender rolling kit from autozone... all you need is that and a hair dryer or heat gun

you'll be blowdrying it all day with a hair dryer, just use a heat gun. LOL

 

[GoldnKnight22]

heatgun + paint = you better be damn careful. lol.

 

[henreeezy xp]

ima put up a thread with some info really quick.