i need help with coilovers!!!

[DarkElegance919]

okay, today i just installed the two rear Hayame full coilovers and waiting to install the fronts soon...i didn't reall get a chance to adjust it the way i like cause i was kinda rushing...on the passenger side rear, the swaybar endlink that's not connected to the lower arm bolt wouldn't tighten, it just keeps turning and turning when i'm tightening it...should i get a new one or doesn't matter? and when i took it for a test drive, i keep hearing clunking noise every couple of bumps...i'm pretty sure someone here had/has this happened to them before. how to fix it? thanks!

And i ride is really stiff/rough i might mention... haha

 

[DarkElegance919]

and i think the clunking noise is from the coilovers...not sure

 

[Wildman]

how low did you set the rear?

clunking is most likely either a loose top nut (just double check them) or if you slammed it, the springs hitting the perches on bumps

 

[DarkElegance919]

right now there is about a two or two and a half fingure gap, i already double checked the top nuts. and i hear these clunking noises even on roads that aren't smooth...i hate running into problems like these....oi

 

[DarkElegance919]

anyone else? i wanna fix this problem!

 

[shavedaccord]

you have to stick a 5mm allen wrench in the end of the end link bolt while u put a wrench on the nut....here is a picture of the fronts..works the same way..

 

[DarkElegance919]

theres a hole in the stud?? whoa i didn't know that...haha i'll go check it out asap. thx!

now bout the clunking noise anyone?

 

[nexTOme]

you are lowered now....but without me???!!!! you're a traitor.....hahaha
ahhh i was going to tell you about endlink....and im sorry cant really help you on that endlink.....

i was just excited for you....i need to lower my car....:sigh:

 

[DarkElegance919]

you are lowered now....but without me???!!!! you're a traitor.....hahaha
ahhh i was going to tell you about endlink....and im sorry cant really help you on that endlink.....

i was just excited for you....i need to lower my car....:sigh:

haha Thanks...sorry bro, but it was time for me... soon it will be your time! haha

 

[shavedaccord]

Could be because the end link was loose when you took it for a test drive