Led strips

[mista jc]

Okay, they say they have a + and - wire. Which means you'll have to tap them onto an existing + and - wire to receive power from.

You can do this from your gauge cluster for interior. Also for headlights tap them onto your 9006 harness.

Tapping means splicing wires, connecting + and - to black and red(+ and -) Don't test your lights before applying electrical tape on exposed wires. this will cause a short and you'll blow fuses.

Good luck!

 

[GoldnKnight22]

^^^ CORRECTION: RED is (+), BLACK is (-) or ground.

 

[CG6Lemon]

well i only want them on with the corner lights. Do i tap them onto the bottom of the headlight where the amber strip is?

 

[ryan s]

^ then theyll be on whenever the headlights are on.

do you want that?

 

[nyknick1015]

if u want them when u turn the corner lights on then when u take off the fender on each side the harness is gonna show 3 wires... tap into the red and black wire... not the green... if u do with the green, its gonna blink everytime u put ur signal on... unless thats what u want

 

[CG6Lemon]

i only want them on with my corner lights and i dont want them to flash or blink.

 

[confuseid]

aw you guys are so harsh.

Just splice them to your running lights.
black on black (or chassis), power on power.
ya dig?
Soldering iron ftw

 

[ryan s]

lemon soldering

lemon wiring

we might lose another dep, folks

 

[GoldnKnight22]

Ok Lemon, this should require absolutely NOOO superglue.

What time you starting this project? I'll wait 10 mins then call an ambulance for you, and a tow truck for your car.






ahhhh, always so funny.

 

[CG6Lemon]

lol dammit, ill try confusied thx. SCREW THE REST OF JOO!