MikeF
New Member
Need help! I replaced the plugs, wires, distributor cap and rotor today but when I was tightening the screw which retains the rotor inside the distributor cap, it snapped off leaving the screw head in my ratchet and the rest of the screw barely holding the rotor cap on. I've turned the motor over and the car runs fine but I really don't trust not having the rotor properly screwed into place.
Any ideas to remove the half a screw would be greatly appreciated. Otherwise I need to buy a whole new distributor right?
FYI, this is a 2001 Honda Accord, auto with the 2.3. (ULEV-VTEC)
-Mike
Any ideas to remove the half a screw would be greatly appreciated. Otherwise I need to buy a whole new distributor right?
FYI, this is a 2001 Honda Accord, auto with the 2.3. (ULEV-VTEC)
-Mike