Brad2274
Well-Known Member
could replace the arms with those adjustable camber ones made by eibach, i think?
the grease thing will unscrew.
Ive done alot of these type of balljoints, and never worn out the opening... unless you press it incorrectly or beat it in with a hammer lol. Your basic otc balljoint tool does the trick and makes it easy
Those after market ball joints that adjust camber are ok... dont quite hold up. Great for adjusting camber, just gotta pay attention on how you put the balljoint in. If its not sitting straight, youll be adjusting caster lol.
i'm a bit confused here. I thought you could set them -1.5 to +1.5 camber, so it would be like an off-center joint/circle. Near 0 would be scary cause the joint would move back, or fwd :O The 3*............