taking apart cruise control button...

[thejameshimself]

anyone got advice on how to do this?

 

[JMillerUA6]

What exactly do you mean by "taking it apart"? To take it out you need to remove the coin tray and the screw behind it. Then carefully remove the vent and buttons. Remove the wire harness from behind the button. Then the button itself is just held in by two clips on each side.

 

[BadgerType]

werd....

 

[thejameshimself]

i actually meant the button itself... figured it out myself though:

1) remove the two springs on the top and bottom that hold it in the panel
2) dremel out the four hooks holding the outer housing in place

it'll slide off then you can get unhook the other latches on top and bottom to get into the guts

thanks anyways guys!

 

[BlkCurrantKord]

I dont remember it being that labor intensive. I think I just popped mine out w/ a flat head screwdriver and then unhooked the harnesses from it.

 

[thejameshimself]

i meant the whole fudgin button:

anyone care to guess what i'm doing?

 

[NINaudio]

LED replacement? I don't remember it being that difficult to get to when I replaced mine either...

 

[JMillerUA6]

anyone care to guess what i'm doing?

Your hooking your NAWSSSS up to it like DOM in TFATF, you know........like when he had it hooked up to his Hazards !!! ****Z mad tYte yO!!!

 

[BadgerType]

Drift on EH had his nitrous hooked up tht way... sorta. the tilt was the purge and the open/close was suppose to be the remote opener. i was gonna do somthing similar but got way too lazy to actually doit.

 

[thejameshimself]

Your hooking your NAWSSSS up to it like DOM in TFATF, you know........like when he had it hooked up to his Hazards !!! ****Z mad tYte yO!!!

^^^made me crack up mid cal II class...

NIN wins... replaced bulbs w/ 5mm leds (i managed to cram 3 in the moonroof!)

i already finished the ac and clock, so all that's left now is the cluster and the radio...