to wire it oem ish than yea prolly alot of work..but if you want them just to work than find the correct pin out on the plug that makes them slide,recline ect..and hook them up to a 12v source when your ign is on..put a small like 10amp fuse inline just to be safe..or w.e the factory one is..i cant remember off hand.
This. There are only a few wires you need to give power and ground to to get the seat to move, the rest are for seat position memory (driver 1 & 2 BS).
Blue and red wires are power, black is ground. Both power wires need a 20A fuse and I'd use some 16 gauge or thicker wire. I wouldn't mess with the heater, if it has it. Be smart, use a relay. You can grab a key-on signal in the radio harness if that's easiest.
yes the fuse is in the passenger side..and mayb you might have the plug for it under the seat/carpet..who knows they might be cheap and made one harness for all models...ha