What'd you do to your accord today?

[kn0x47]

test fitted a single foglight

refinished my passenger headlight and tried out the LED bulb in the strip. buffer broke the second i finished the headlight. guess i'll have to buy a DA polisher now

 

[CG6Lemon]

I would like to recommend the griots garage 6" da. It offers a lifetime warranty and 2nd most powerful da in the market, right behind the rupes big foot da.

 

[kn0x47]

thanks lemon

 

[bairdandrew77]

Put everything back together so a potential buyer can look at a running vehicle, but he never showed up. Oh well, more time for me to spend with it until it's gone

 

[soccerchamp16]

Today I installed interior LEDs and LEDs for my DRL. I also fixed my fog light connection. And the last 2 days ive been fixing my friends 6th gen sedan
Problem: Wouldnt start, no power to the starter, fuel pump anything besides the headlights and such. Transmission stuck in park unless you used the release. Relays, fuses etc all good..
Solution (I think): Neutral Safety Switch (99% positive) If not that I will have to start checking all the wires in the ignition harness and after that swap a ECU in it and see if thats the issue.

 

[Hello People]

STILL working on the passenger side LED strip. Soldering gun quit working on me as I was about to solder the last connection.

Also restored darkness back to various external trim pieces. I did the cowl where the hood meets the windshield, window trim, body molding, and rocker panel. I don't have a before and after on my accord, but here's a comparison on my dad's ST1100 (still a Honda).

(Left is before, right is after)

 

[Brad2274]

Today I installed interior LEDs and LEDs for my DRL. I also fixed my fog light connection. And the last 2 days ive been fixing my friends 6th gen sedan
Problem: Wouldnt start, no power to the starter, fuel pump anything besides the headlights and such. Transmission stuck in park unless you used the release. Relays, fuses etc all good..
Solution (I think): Neutral Safety Switch (99% positive) If not that I will have to start checking all the wires in the ignition harness and after that swap a ECU in it and see if thats the issue.

Sounds like ignition switch, mine went out and caused those problems, very common, it was recalled i believe.

STILL working on the passenger side LED strip. Soldering gun quit working on me as I was about to solder the last connection.

Also restored darkness back to various external trim pieces. I did the cowl where the hood meets the windshield, window trim, body molding, and rocker panel. I don't have a before and after on my accord, but here's a comparison on my dad's ST1100 (still a Honda).

(Left is before, right is after)

did you use a chemical? looks good but wears off after a while, best way is with a heat gun no joke lol, did jeep cherokee bumpers all chauky now look brand new

 

[soccerchamp16]

Sounds like ignition switch, mine went out and caused those problems, very common, it was recalled i believe.

Not it actually, but now we know its not the neutral safety switch either... Narrowing it down to the ECU or the ECU ground...

 

[Dat99accord]

Washed and added this decal on. Thoughts?

 

[SykVSyx]

Washed and added this decal on. Thoughts?

You should have lowered the decal.

Looks a bit high on the windshield.