where to jack

[meximan16]

take the bumper off!!! lol that's what i do to get up on my ramps, and am pretty slammed

 

[RedAccord02]

haha i thought about that. Well i guess thats for the stock people.

 

[Crono139]

i thought about it but dont want to break cuz of the weight of the car

The wood doesn't support the weight of the car. The ground does.

 

[tomcarhonda]

Just use 2 scissor jacks on the side. Them Pinch welds. Then get it high enough so you can slide under the front bumber and under the engine bay. Use bricks to sub for a jack if you don't have any.

Or jack up the sub frame in the front, the middle of the front should do it.
Make sure to put wheel blocks behind the rear tires.
As always SAFETY comes first, buy 2 Jacks to hold steady the car or as mentioned up top, you can use bricks to hold up the car.

Hope this helps, as well as the before posts.

 

[dvilla5506]

thanks everybody didnt know i would get so many answers....did have ramps but apparently when my brother decided to clean out the side of the house threw those away.....i tried jacking up from the front but it sounded like it was guna give so i stopped

 

[cl206]

Slammed you say?
check these out:

http://www.mustangworld.com/ourpics/News/mwramps/index.htm

depending on your tools, you can easily make them and even change the specs to suit your needs.

-cl206

 

[SykVSyx]

To the OP, there are jackpoints under the car, the amount of pics on here of jack points(type those words in 'Search'), shouldn't be hard for you to see where to jack the car up.

 

[Ryan]

just buy car ramps. Thats what i have. works like a charm

 

[F23A1AT]

just buy car ramps. Thats what i have. works like a charm

WTF dude this thread is two years old!

 

[jdmcg3]

WTF dude this thread is two years old!

+1.

just buy car ramps. Thats what i have. works like a charm

how many pages back did you dig so you could post something that doesnt even answer OPs question. and has already been covered.

You could also make ramps with a couple 2x4s

super sketch.