New profile posts
-
D
dbruskla wrote on RedRyder's profile.
Hello, I recently had picked up a Richie V6 Module of of someone locally to do a 6 speed swap in my accord. He didnt have the install packet with instructions, and was wondering if you or someone you know have them at all or a picture of them? im trying to figure out what wires need to go where when I do the install.
-
R
Rusty Accord wrote on Connie's profile.
Connie, I think I found some polyurethane bushings for the rear of our cars. Don't know if their prices are in line or not. Here's a link to them.
http://siberianbushing.com/catalog/HONDA/USA/ACCORD/ACCORD/-?utm_source=TN_forum_Free_Test
I got the link to them from Toyota Nation, since I'm a member over there (for my Geo).
http://siberianbushing.com/catalog/HONDA/USA/ACCORD/ACCORD/-?utm_source=TN_forum_Free_Test
I got the link to them from Toyota Nation, since I'm a member over there (for my Geo).
-
F
F23accordowner wrote on Russianred's profile.
Hey man, my name is Steven and i have seen you post tons on here. If you didnt care to answer some helpful questions for me i would appreciate it.
I have an old motor that i will be tearing down to see why it had terrible compression in one of the cylinders next week. (its been sitting at the shop for over 2 yrs). The one that is installed now is a F23A from japan. The first motor was bored 20 over, so i know if i use that motor i will need 86.5mm pistons. The rods i was looking at using were from RaceEngineering for like 480 bucks. And they even do a package deal for like 980 bucks for the 86.5mm CP pistons. But was wondering doesnt our block or whatever require FRM pistons or do i just use regular forged pistons?Any and all help is appreciated. BTW goal is 400ish Hp with 750cc injectors and running on E-85, should the factory sleeve hold this if i use upgraded rods/pistons and head studs?
I have an old motor that i will be tearing down to see why it had terrible compression in one of the cylinders next week. (its been sitting at the shop for over 2 yrs). The one that is installed now is a F23A from japan. The first motor was bored 20 over, so i know if i use that motor i will need 86.5mm pistons. The rods i was looking at using were from RaceEngineering for like 480 bucks. And they even do a package deal for like 980 bucks for the 86.5mm CP pistons. But was wondering doesnt our block or whatever require FRM pistons or do i just use regular forged pistons?Any and all help is appreciated. BTW goal is 400ish Hp with 750cc injectors and running on E-85, should the factory sleeve hold this if i use upgraded rods/pistons and head studs?
hello !!\
is it yours?
http://www.6thgenaccord.com/forums/picture.php?albumid=1234&pictureid=6791
if so, please send me more pics : )
greets from Poland
is it yours?
http://www.6thgenaccord.com/forums/picture.php?albumid=1234&pictureid=6791
if so, please send me more pics : )
greets from Poland
