Recent content by Omega83

  1. O

    Timing belt??? Please advise..

    Doing mine tomorrow at 171,360 miles and I drive the s#!t out of my car! Never been done before.... I got REALLY lucky!
  2. O

    Wheel bearing replacement?

    Same thing happened to me two years ago. Like said before, they do have to be pressed out and back in. I have heard of people using a heavy hammer and a peice of wood to beat them out and then back in, but they are in there TIGHT! It would take a lot of banging and that can't be good for the...
  3. O

    Another TrimBrite Project

    Not too shabby! Hell, I might try this myself... I have the same problem. As far as the rust goes... by the time it rusts through I might have the funds for a CF hood.
  4. O

    Help With a Carseat.

    I went to the local police station to have my son's carseat properly installed. The officer said that just using the seat belt through the back was enough. Just pull the belt all the way out till it clicks, feed through the back of the seat, buckle it and cinch it down with all of your...
  5. O

    Timing Belt Kit?

    I feel ya buddy! I've got two kids and go to school full time. A lot of people on here have a steady income and apparently a lot of free time. I don't see anything wrong with buying parts off of ebay, as long as they are quality parts. It looks to me like the parts in that auction are...
  6. O

    *MASSIVE* Mid-Missouri Meet 6/4/2011

    Nice! Thanks for the pointers :eusa_wall:
  7. O

    Replace Mount When Rebuilding Transmission?

    Yeah... Thats why I waited so long... $ Do yourself a favor and have all of them checked out cause it is a chain reaction... one goes bad and it stresses another and so on...
  8. O

    Replace Mount When Rebuilding Transmission?

    I drove my V6 coupe for a couple of months with the trans slipping. A few weeks after I had the tranny rebuilt I started noticing the engine "jumping" or making a loud clunk noise when I would put it into gear or accelerate hard. The tranny slipping for those couple of months had broken my...
  9. O

    *MASSIVE* Mid-Missouri Meet 6/4/2011

    Sounds good.
  10. O

    Any Others with the DC Sports 4-2-1 Header

    It did to mine but it also made for a rough idle and threw an engine code
  11. O

    You might be "too low" if...

    My SLR was stolen out of my car last December. Still haven't replaced it and that was my only camera except for my POS phone camera. As soon as I get a new camera I'll put up pics.
  12. O

    You might be "too low" if...

    I'm still playin with the height. I may go back down 1/2 inch or so... not sure. You gotta compromise when your daily driver can't be daily driven anymore.
  13. O

    You might be "too low" if...

    Lol... That happened to me with a trash can lid in my garage. My car smelled like melted plastic for weeks every time I drove it.
  14. O

    You might be "too low" if...

    Noob? Ha! I've been driving this car for eight years lowered 2.5+ inches. Just decided to go to the flo... just ended up being too much for the daily things I do. Did anybody actually read the initial post to the end where it says, "Anyone realize they were too low and have a good story...
  15. O

    You might be "too low" if...

    Yeah... the car wash probably wasn't the smartest move, but there was no way around the speed bump. Had to pick up my son and it spreads the whole width of the pick up line... can't even get into the frickin parking lot without going over one!
See more

Latest posts

Random media

6thgenSIG1
20201023_174810
SdrevKendrieFundraiser122
The Slab Finale
new f 1 racing clutch
Back
Top