shenaniganz08
Well-Known Member
what's a half shaft bearing (i plan on replacing my axles, curious if i need to replace these as well)
Bad Axle?
- Thread starter kn0x47
- Start date
GravitySucks
Well-Known Member
Also known as the CV joint.
xi0utlawstarix
Well-Known Member
http://www.hondaautomotiveparts.com...6&catcgry4=KA4AT&catcgry5=DRIVESHAFT+(V6)+(4)
#20...I think I need to replace mine too. Might just get the whole assembly #15.
LeBirdNest
Titleist
Did you figure it out, Jonathan?
kn0x47
Senior Member
I'm actually in Miami this week so no. Both me axles have some play so I'll probably end up just buying two new ones. I'll keep y'all updated as to if this gets rid of that scrubbing noise or not.
kn0x47
Senior Member
Anyone recommend any brand of after market axles? I was gonna buy some at advanced but read bad things about theirs
I found out my drivers side makes the same and the other day I kept hearing popping noises from both front wheel areas. I'm gonna make sure no bolts are loose any where but I'm pretty sure its the axles
I found out my drivers side makes the same and the other day I kept hearing popping noises from both front wheel areas. I'm gonna make sure no bolts are loose any where but I'm pretty sure its the axles
DarkSideAccord
nadeshiko fobz ftw..
haven't heard of any issues from autozone ones.. lifetime warranty too haha
LeBirdNest
Titleist
I put duralast on mine but the boot went bad 4 months later.
RedRyder
Save the manuals
Does Beck Arnley make some? I'd trust them.
kn0x47
Senior Member
I checked and they only have boot kits
I sent tasauto an email to get more info about theirs too
