puzzlemaster94
6GA Connoisseur
So recently I was driving and my brakes would just go the floor when going into a turn.
I replaced my master cylinder, bench bled that and problem still persists.
I bled all the calipers twice, and the problem is still there.
When turning, the lines are not being touched, rubbed, etc...
It's wierd, because they will go the floor only on turns. Then you pump them a few times and they are back. I've read though a few other forums, and apparently this problems occurs very rarely. From other posts, people are saying it's either a brake booster or a "proportioning valve".
Just trying to get some insight on this
I replaced my master cylinder, bench bled that and problem still persists.
I bled all the calipers twice, and the problem is still there.
When turning, the lines are not being touched, rubbed, etc...
It's wierd, because they will go the floor only on turns. Then you pump them a few times and they are back. I've read though a few other forums, and apparently this problems occurs very rarely. From other posts, people are saying it's either a brake booster or a "proportioning valve".
Just trying to get some insight on this