sonni_kuba
6GA Supporting Member
Installed few days ago, can't believe how smooth the ride is with a one finger gap on 18s.
FF type2
- Thread starter restux
- Start date
fastflyinaccord
Well-Known Member
Wouldn't see me rolling around with 7.5mm spacers without extended lugs. I put 5mm on my car and there wasn't much thread for the lugs to grab with the wheel on.
I'm running Ap2 s2k wheels on my car - staggered. Check out link below and on F&F Type Two's - fenders are rolled on rear and stuffed a 245/45/17 rear and 225/45/17 front running 15mm (bolton spacer) no need for extended bolts and 3mm front.
http://www.6thgenaccord.com/forums/showthread.php?t=35635
Awesome, glad they worked out for you!
http://www.6thgenaccord.com/forums/showthread.php?t=35635
Awesome, glad they worked out for you!
It was fine, it grabbed enough thread for temp use of car. The only issue after was when I was going to install my extended was taking the lugs off it snapped most of the studs. It was fine regardless in the end.
Going to run extended in front with 10m and 15m in rear soon
@sonni_kuba : glad you love your ff type 2 theyre awesome! I was going to get 1, then my friend said just pay a bit more for 2 its worth it.
@NASOHC : nice, I wasn't able to due to the s2k wheel are stagger themselves. front was :16" x 6.5", +55 offset, Rear: 16" x 7.5", +65 offset. It was fine when I had the 7.5m spacer in rear holding by a few threads on each stud.
Last edited:
