Search results

  1. 1

    Meximan's 5spd wtb.

    Re: Meximan's wanted/ i item f/s pm sent
  2. 1

    Need help with Interior swap - Airbags

    They will fail you for an airbag light? Here in Illinois you only fail for emissions related codes/ check engine lights.
  3. 1

    Need help with Interior swap - Airbags

    Taken directly from Alldata- Ill get you a pic later... "Because the seats are made by more than one manufacturer, make sure you replace any seat components (seat-back cover, frame, etc.) with the correct parts. The name of the seat manufacturer is indicated on the seat-back."
  4. 1

    Need help with Interior swap - Airbags

    In theory yes, a two ohm resistor would work as the resistance of most air bags is about that much. IIRC though, the 01 and on Accords used dual stage airbags. Although, I'm not sure if the side air bags are dual stage or not.
  5. 1

    cars been maxing out lean on AFR 17.+,sluggish

    This makes sense if you are running lean. The PCM is trying to compensate by adding more fuel, it should smell of fuel. A clogged/gunked up fuel filter could cause your complaint and casue the car to run lean. I know there is one in the tank like you stated but I'm fairly certain there is not...
  6. 1

    Sedan rear seat in a coupe???

    The sedans dont have a split. The whole seat back folds down and forward. It reaaaalllllly sucks. Also, I don't believe they will fit. The coupe seems much smaller back there than the sedan. Try it and find out?
  7. 1

    Spring shock suggestion for a minimal drop...

    Yes, I am currently on this set-up and have been on it for about 40K-50K miles. The drop is not huge but it gets the job done. I now wish I would have just saved my money and gotten coilovers. PM for pics.
  8. 1

    do i need a cat?

    It does add quite a bit towards the top end from about 4500RPM to redline, however, it is SUPER loud in the car. I could only bear the noise for about a month. The added oomph was nice but it got to the point where it felt like my ears were going to bleed every time I drove it. Test pipe will...
  9. 1

    inputs on the fitment

    Maybe I do, maybe I don't. but I just don't see the point in super low offsets. Sure, cars looks great with what you would call "hellaflush" but its just plain silly. Stretched tires to fit retard wheels that are more expensive than the car, huge negative camber that is probably doing more...
  10. 1

    inputs on the fitment

    Not to mention the massive amount of stretch (read: dangerous and stupid) One would think that he would need so much camber just so they would poke out mexi-style.
  11. 1

    inputs on the fitment

    Probably quite a bit, probably over -2.5 degrees. This is a purely a guess...
  12. 1

    Both O2 sensors

    Denso would be the best option but will cost quite a bit more. The Bosch will work just fine but requires more work. Most people will tell you that OE or Denso is best but I (as well as others) have been runinng 2 Bosch universals for about 6mos now with no trouble.
  13. 1

    Both O2 sensors

    The sensor actually reads through the wires. Its hard to convey through text, just trust me on it though. Yes, most likely your sensors are probably in perfect working order, but since you hacked all the wiring up, you have left yourself no choice but to get new sensors. I recommend the...
  14. 1

    Both O2 sensors

    Air gets into the splices and throws the reading off.
  15. 1

    My new ride!

    Thats awesome! RB25?
  16. 1

    Air Vent Control

    Both the manual and auto climate control panels have a self diagnostic mode, much like OBDII, although there are only two codes possible. If you would like, I can go into greater detail about how to retrieve the codes.
  17. 1

    Oxygen Sensor CEL Help

    You probably wired it incorrectly. I have been using Bosch universal for quite some time. I can post a wiring diagram for any other users who would like to use a universal unit.
  18. 1

    Failed CO Emissions BAD!!! UPDATED

    Are you sure the CYP is OK? An intermittent signal could cause a miss every now and then which could lead to your high NOx situation.
  19. 1

    Not quite. I am going to school at Southern Illinois University (the school that found the...

    Not quite. I am going to school at Southern Illinois University (the school that found the Toyota TPS fault) and studying automotive technology. I just had a class last semester about emissions and their respective fault codes and I currently work at Eaton answering tech support calls for...
  20. 1

    Failed CO Emissions BAD!!! UPDATED

    This is not going to be your problem. NOx emissions come from high combustion temps (like you said) and high combustion temps usually come from lean conditions. Some examples could be a lean miss (bad plugs, bad leads, issue with secondary coil, etc) or it could be a cooling issue (bad thermo...
  21. 1

    FS: ★ Russianred's Replacement Parts For Sale Thread! *UPDATED: 6/27* [OEM][ENGINE] ★

    Re: *UPDATED 5/6* Russianred's For Sale Thread [ NO 56K ] I can vouch for Nikita, he is an awesome seller and an all around stand-up guy. I recently purchased a full OEM exhaust from him and the service was nothing short of excellent. He was great with communication and prompt at answering...
  22. 1

    Feedback for Good/Bad Transactions

    Member: Russianred Item bought: Full OEM exhaust Feedback: Awesome guy to do business with. The item was exactly as described in words and photos and communication was excellent. He was always pleasant to talk to and would respond to calls, texts, and PMs promptly. Would recommend and would do...
  23. 1

    OEM Exhaust

    F23A1 the DC is ceramic and in good shape. PM me your email for pics.
  24. 1

    OEM Exhaust

    How much would you be asking? If the guy from IL flakes out I'll buy from you.
  25. 1

    OEM Exhaust

    I am looking to buy a used full exhaust (manifold, flex pipe, and muffler *I have a cat*) I have a DC sports manifold and Flowmaster muffler that I would be willing to trade as well. Would be willing to meet seller anywhere in IL or South East MO. Also, I would pay for shipping but prefer...
Back
Top