f22b1 block f23a1 head

[mkdb89-02se]

Is there a jdm f23a that i can get the pistons out of that has the dome to raise the compression a bit? or will i be better off boring the block and sliding h22 pistons in? i figure if ima rebuild the block i mines well do something a lil extra

im pretty sure u cant bore it because of it bein sleaved from tha factory... and if u can then not very much if any... if i was u i wldnt mess with that its gunna cost u more pain suffering and money...and on top of that power

 

[98ExAccordwv]

Doing this would be pointless. Just replace your rings. Might as well get new rod bearings as well. You won't even have to pull the motor if you don't want too, albeit will be easier if you do.

 

[mkdb89-02se]

^ fo sho

 

[cudablack2004]

well i decided to used k20a pistons to freshen the block up and raise the compression those pistons are cheap and slide right onto my stock rods and same bore thanks alot guys ima make a thread called sohc budget all motor build so yal can check out

 

[F23A1AT]

well i decided to used k20a pistons to freshen the block up and raise the compression those pistons are cheap and slide right onto my stock rods and same bore thanks alot guys ima make a thread called sohc budget all motor build so yal can check out

Those pistons don't just slide right in there. I hope you look some more before you try that or you are going to have even bigger problems, trust me.

 

[mkdb89-02se]

Those pistons don't just slide right in there. I hope you look some more before you try that or you are going to have even bigger problems, trust me.

i forgot wear but some one told me they did... k2o into tha f23... doesnt make seense but i took there word for it knowing id never try it...but it makes sense sense they are diff engine sizes...i think tha k20 is smaller...i wanna take a k24 out a 05 with a manual tranny and swap it into mine... but that wld b way into the future ha ha

 

[F23A1AT]

Oh they'll fit but they aren't just going to drop in. The info is on this site as to how to make them fit I'm just hoping he looks so he doesn't get fvcked even more than his wild ideas already will. I mean he has changed his mind three time in less than two pages.

 

[cudablack2004]

Im just lookin for some good advice on a nice rebuild on a tight budget the k20a pistons will be the best way to go

 

[BlkCurrantKord]

Find where the crank angle sensor is on the F22b1, if its the same as your f23, just use that OR - find a junkyard motor, rebuild yours, or something.

Engine displacement has nothing to do with swapping out K20 pistons for the stock ones in the F23, you do have to rotate them though.

 

[mkdb89-02se]

good luck with tha build