Still waiting on one of the chemicals to clean the flux residue off. What a mess!! I did clean up (to a degree) what was left from soldering the LEDs and finished the strips today. Got the remaining components in place (resistors, diodes and connector) today which meant I could test them to see if everything worked as planned.
Finished boards (front and back); the only components on the LED side are the LEDs...
...since the strips will be behind clear reflector strips, you probably won't even see the LEDs when unlit.
White LEDs lit:
Amber LEDs lit:
This was just a quick test so the switchback circuit is not in place. The boards are just connected to a 12V power supply.
Finished boards (front and back); the only components on the LED side are the LEDs...
...since the strips will be behind clear reflector strips, you probably won't even see the LEDs when unlit.
White LEDs lit:
Amber LEDs lit:
This was just a quick test so the switchback circuit is not in place. The boards are just connected to a 12V power supply.
