New Clutch and This happens!!

[BkzTafetta]

So i was putting a new clutch and flywheel and i told my cuzin to disconnect the o2 sensor and i guess he forgot so when i pulled down the subframe it pulled the plugs down with it and ripped out the wires...now there are 4 wires and im not sure which ones go where...they are colored differently on both plugs...can sum1 take a pic of theirs so i can follow it or tell me which wires go where....also i got a ACT prolite 9.9lb flywheel and a ACT pressure plate and Extreme street clutch....now...what stage is this clutch? it didnt say when i ordered it...it only said torque capacity of 386ft lbs and 95% clamp load increase.....Thanx!!!

 

[HondaLuver83]

I would try to find a wiring diagram or just trial and error plug and guess. Sorry, wish I knew more about it.

 

[BlkCurrantKord]

Just buy a new sensor or try repinning it. As for the clutch, there's gotta be a part # on the box somewhere.

 

[hotaccord243]

look at the part number on the disc, plate, and flywheel. You should be able to search the internet for it and find what stage or type it is....

 

[BkzTafetta]

ill see if i find a wiring diagram sumwhere.....i would try the trial and error but how would i know if i got it right??

kool ill check the part numbers...

 

[BkzTafetta]

thanx guys!!

 

[1NonlyAccord]

i didnt think ACT had there stuff classified as "stages" just street,race,xtreme..ect ect? i could be wrong.
little off topic,but did you just drop your subframe or completely remove it? sorry for asking due to having clutch issues and spending over 600$ each time getting it replaced/worked on. 950$ was my last bill from the shop..

 

[BkzTafetta]

hmmmm true...kinda makes sense since mine said extreme clutch kit....well drop/remove pretty much the same thing....you need to remove it cuz you need the room to drop the tranny out...do they really charge that much to change a clutch??

 

[swollen_cu]

i didnt think ACT had there stuff classified as "stages" just street,race,xtreme..ect ect? i could be wrong.
little off topic,but did you just drop your subframe or completely remove it? sorry for asking due to having clutch issues and spending over 600$ each time getting it replaced/worked on. 950$ was my last bill from the shop..

damn if you down here in New Orleans, I'd do it for you for 175 labor homey hook up!

 

[1NonlyAccord]

they charge 350$ for labor..then w.e suprise add ons..but last time...was clutch,flywheel.motor mounts.so added up