So I fabbed a catch can setup...

[EmMinODaGreaT]

And here is some of the progress, the can will sit on the driver side, pretty much conforms to the motor mount....

And yes its not 100% complete, I need to clean up the top, (where the filter goes) and polish it up...

But heres the run down, the top is a filter (like that of a hvac type in a home) and I did it this way to clear the hood.

 

[kn0x47]

cool. that looks pretty big

 

[EmMinODaGreaT]

At its widest part its 5'' and about 8'' high

 

[Drift]

baffled?

 

[EmMinODaGreaT]

No, its just a catch can, no need for baffling. Breathers, and a filter

The filter goes up, and lines run into the left hand side.

 

[akoutmos]

Looks really nice . Usually people put like some steel wool in there so that it doesn't slosh around during corners and spill out or wet your filters

 

[turboaccord98]

That's pretty sweet looking. Nice work.

 

[Drift]

No, its just a catch can, no need for baffling. Breathers, and a filter

There is always a need for baffling in a catch can. Nice work regardless.

 

[EmMinODaGreaT]

I can see the baffling, or steelwool for road course/auto x..

But my mindset is that IF that catch can gets full, i have bigger problems w/ my motor.
Its just there to help relieve crankcase pressure, should NEVER fill up.