Dinzdale40
Large Member
yea the rear is cake.....on the front the steering knuckle that encases the axle gets in the way....you can make them fit...but...it will mess up your threads
remove the wheel, remove the brake rotor. hit the studs with some PB blaster or WD40. Bang them out with a rubber mallet, or use a C-Clamp or whatever you want. Hammer the new ones in enough to get some threads through and pull them the rest of the way into the hub by tightening some nuts on.
I need a new one in the front realllly bad, I've been rocking three studs for a whillle
first off the axle nut is a 36mm...let me tell u this is alot of work and headach and ur looking at spending about couple hundred to do this i just finished doing mine..first u gotta take the caliper,rotor off.next take the whole knuckle assembly off ur gonna have to get the spindle pressed out of the hub about 30 bucks each side to press it out then ur gonna have to buy new hub bearings 85$ each from honda because there gonna break no matter wut.. u "cannot" get the studs out without taking the spindle out from the hub this is somewut of a project..good luck i would recomend changing out all ur ball joints well the car is down..