Mod: 3m di-noc & red led arrow

[Jephu]

mind if i ask where you tapped into the signal wire for the leds?

I wired them to the turn signal. Exactly like same way for the sidemarker.
+ green
- black

 

[FunnyVictor86]

mirror turn signals look sickkkkkkk ... i would do it hyper white tho ... prob wouldnt even see it during the day but i would only really need them at night

 

[KnightRyder]

I wired them to the turn signal. Exactly like same way for the sidemarker.
+ green
- black

so you just tapped into the wires in the engine bay area right behind the headlights? or did you trace the wires back into the cabin?

 

[Jephu]

so you just tapped into the wires in the engine bay area right behind the headlights? or did you trace the wires back into the cabin?

its spliced into the turn signal wires in the engine bay. I was able to trace the wire from the turn signal bulb connector by pulling on the fender liner and traced the wire back up to the engine bay area and I spliced the wire there.

 

[KnightRyder]

sounds good, thanks.

 

[1NonlyAccord]

is the 3m decal flush,or not? Maybe something that can be cleared over to "appear" real CF?

 

[Jephu]

There is texture feel to it.

http://g35driver.com/forums/picture...-neffy-wrap-carbon-fiber-fabric-pictures.html

 

[bdeitemeyer]

is the 3m decal flush,or not? Maybe something that can be cleared over to "appear" real CF?

It has a texture, but there are links online to people that have started applying clearcoat over it and achieving positive results.

 

[slowrider87]

hey i just installed the same kind of turn signals in my mirrors today. only i can't get the two ball joints that adjust the mirrors back into their sockets, how did you pull it off? any specific re assembly procedure? its really annyoing that i can't get my mirrros to angel the way i need them.

 

[Jephu]

hey i just installed the same kind of turn signals in my mirrors today. only i can't get the two ball joints that adjust the mirrors back into their sockets, how did you pull it off? any specific re assembly procedure? its really annyoing that i can't get my mirrros to angel the way i need them.

once you have the mirror on, just tilt and push the mirror on one side of ball joint until it clicks and repeat for other joint.