I wired them to the turn signal. Exactly like same way for the sidemarker.
+ green
- black
Mod: 3m di-noc & red led arrow
- Thread starter Jephu
- Start date
I wired them to the turn signal. Exactly like same way for the sidemarker.
+ green
- black
FunnyVictor86
Well-Known Member
mirror turn signals look sickkkkkkk ... i would do it hyper white tho ... prob wouldnt even see it during the day but i would only really need them at night
KnightRyder
Well-Known Member
so you just tapped into the wires in the engine bay area right behind the headlights? or did you trace the wires back into the cabin?
its spliced into the turn signal wires in the engine bay. I was able to trace the wire from the turn signal bulb connector by pulling on the fender liner and traced the wire back up to the engine bay area and I spliced the wire there.
KnightRyder
Well-Known Member
sounds good, thanks.
1NonlyAccord
Well-Known Member
is the 3m decal flush,or not? Maybe something that can be cleared over to "appear" real CF?
There is texture feel to it.
http://g35driver.com/forums/picture...-neffy-wrap-carbon-fiber-fabric-pictures.html
http://g35driver.com/forums/picture...-neffy-wrap-carbon-fiber-fabric-pictures.html
bdeitemeyer
Well-Known Member
It has a texture, but there are links online to people that have started applying clearcoat over it and achieving positive results.
slowrider87
Well-Known Member
hey i just installed the same kind of turn signals in my mirrors today. only i can't get the two ball joints that adjust the mirrors back into their sockets, how did you pull it off? any specific re assembly procedure? its really annyoing that i can't get my mirrros to angel the way i need them.
once you have the mirror on, just tilt and push the mirror on one side of ball joint until it clicks and repeat for other joint.
